Snorkel S3010E Manuel d'utilisateur télécharger pdf (Page 41)

S3010E - 514226-000-ANSI 37

Chapter 10 – Stowing and Transporting

To prevent unauthorized use and damage, properly stow

the aerial platform at the end of each work day. It must

also be properly stowed while transporting.

Stowing

Use the following procedure to properly stow the aerial

platform.

1. Fully lower the platform.

2. Push the emergency stop button in on the lower

control panel.

3. Turn the control selector switch off and remove the

key.

4. Securely close the pull-out tray.

Transporting

The aerial platform may be moved on a transport vehicle.

Depending on the particular situation, the aerial platform

may be lifted with a forklift, driven, winched, or hoisted

onto a vehicle such as a truck or trailer. Lifting with a

forklift is the preferred method.

The equipment used to load, unload, and transport the

aerial platform must have adequate capacity. The empty

vehicle weight is listed in Chapter 2 and is stamped on

the serial number placard.

The user assumes all responsibility for:

y Choosing the proper method of transportation.

y Choosing the proper selection and use of transporta-

tion and tie-down devices.

y Making sure the equipment used is capable of sup-

porting the weight of the aerial platform.

y Making sure all manufacturer’s instructions and warn-

ings, regulations and safety rules of their employer,

the DOT, and/or any other state or federal law are

followed.

Lifting With a Forklift

Use the following procedure to lift the aerial platform with

a forklift.

1. Properly stow the aerial platform.

2. Remove all personnel, tools, materials, or other loose

objects from the platform.

3. Insert the forklift forks into the folklift pockets located

on either side of the machine (refer to Figure 10.1

and 10.2).

Figure 10.1 – Right side of Chassis

Figure 10.2 – Left Side of Chassis

Caution

Lifting the aerial platform with the forklift forks

positioned improperly can produce enough force

to damage machine components. When lifting the

machine, place the forklift forks carefully. Only use

the designated lift pockets.

4. When lifting the machine, insert the forklift forks di-

rectly and fully into designated pockets while avoiding

contact with the machine side (refer to Figure 10.1

and 10.2).

5. Do not raise the aerial platform higher than necessary

to transport it. Drive the forklift slowly and carefully

when transporting the aerial platform.

Winching

Use a winch to load and unload the aerial platform on

ramps that exceed the machine gradeability specica-

tion. A winch may also be used when poor traction, un-

even surfaces, or stepped ramp transition make driving

hazardous. The machine cannot be winched if disabled

and must be fully functioning before proceeding with the

winching proccess.

Caution

Damage to the aerial platform and/or drive system

may occur if the machine drive system is disabled

while the winching process is being carried out.

Forklift Pockets

1 2 ... 36 37 38 39 40 41 42 43 44 45 46 ... 55 56

Commentaires sur ces manuels

Pas de commentaire

Snorkel S3010E Manuel d'utilisateur Page 41

Commentaires sur ces manuels

Produits connexes et manuels pour Machines spéciales Snorkel S3010E