Snorkel MX19-sn14000-19999 Manuel d'utilisateur télécharger pdf

Safety Rules and Operating Instructions

Operator Manual

WARNING

All personnel shall carefully read, understand and follow all safety rules,

operating instructions, and the Scaffold Industry Association’s

MANUAL

OF RESPONSIBILITIES of ANSI A92.6-1999

before performing

maintenance on or operating any UpRight Aerial Work Platform.

Safety Rules

NEVER

operate the machine without first surveying the work area for surface hazards such as holes,

drop-offs, bumps, and debris.

NEVER

operate the machine if all guardrails are not properly in place and secured with all fasteners prop-

erly torqued.

SECURE

chain across entrance after mounting platform.

NEVER

use ladders or scaffolding on the platform.

NEVER

attach overhanging loads or increase platform size.

LOOK

up, down, and around for overhead obstructions and electrical conductors.

DISTRIBUTE

all loads evenly on the platform. See the back cover for maximum platform load.

NEVER

use damaged equipment. (Contact UpRight for instructions. See toll-free phone number on back

cover.)

NEVER

change operating or safety systems.

INSPECT

the machine thoroughly for cracked welds, loose hardware, hydraulic leaks, damaged control

cable, loose wire connections, and wheel bolts.

NEVER

climb down elevating assembly with the platform elevated.

NEVER

perform service on machine while platform is elevated without blocking elevating assembly.

NEVER

recharge battery near sparks or open flame; batteries that are being charged emit highly explo-

sive hydrogen gas.

AFTER USE

secure the work platform against unauthorized use by turning key switch off and removing

key.

NEVER

replace any component or part with anything other than original UpRight replacement parts with-

out the manufacturer’s consent

NEVER elevate the platform or

drive the machine while elevated

unless the machine is on firm

level surface.

NEVER sit, stand, or climb on

guardrail or midrail.

NEVER operate the machine

within ten feet of power lines.

THIS MACHINE IS NOT

INSULATED.

MX15/19

Serial No. 14000 to Current

1 2 3 4 5 6 ... 11 12

Résumé du contenu

Page 1 - Operator Manual

Safety Rules and Operating InstructionsSafety Rules and Operating InstructionsOperator ManualWARNINGAll personnel shall carefully read, understand and

Page 2

Page 10 MX15/19The Complete Inspection consists of periodic visual and operational checks, along with periodic-minor adjustments that assure proper pe

Page 3

Page 11MX15/19Table 1: Preventative Maintenance ChecklistPREVENTATIVE MAINTENANCE KEYIntervalDaily=each shift or every day50h/30d=every 50 hours or 3

Page 4 - PERATION

TEL: (1) 800-926-5438 or (1) 559-662-3900FAX: (1) 559-673-6184Parts FAX: (1) 800-669-9884801 South Pine StreetMadera, California 93637http://www.uprig

Page 5

Page 2 MX15/19This manual covers all models of the MX 15 and MX19 Self-Propelled Elevating Work Platforms. This manual must be stored on the machine a

Page 6 - RANSPORTING

Page 3MX15/19Figure 2: Emergency Lowering Valve Knob15. Open the Emergency Lowering Valve (Figure 2) by pulling the knob out to check for proper opera

Page 7

Page 4 MX15/19Before operating the work platform, ensure that the Pre-Operation Safety Inspection has been completed and that any deficiencies have be

Page 8

Page 5MX15/19TRAVEL WITH PLATFORM ELEVATEDNOTE: The machine will travel at reduced speed when the platform is elevated.1. Check that the route is cle

Page 9 - Label Installation

Page 6 MX15/19PARKING BRAKE RELEASEPerform the following procedure only when the machine will not operate under its own power and it is necessary to m

Page 10 - AINTENANCE

Page 7MX15/19BY TRUCKManeuver the work platform into transport position and chock the wheels. Secure the work plat-form to the transport vehicle by at

Page 11

Page 8 MX15/19BATTERY MAINTENANCE • Check the battery fluid level daily, especially if the work platform is being used in a warm, dry climate. • If el

Page 12 - PECIFICATIONS

Page 9MX15/19Figure 9: Label Installation1775 PARK ST. SELMA CALIFORNIA 93662 USAModel:______________Serial number:_____________GVW: __________lbs.